Aeroponics Calculator

Aeroponics System Calculator

Disclaimer: This tool provides estimations for planning purposes only. Actual requirements may vary based on specific plant types, environmental conditions, chosen equipment, and desired system complexity. Always consult detailed guides or experts for precise setup and nutrient regimens.

Number of Plant Sites (Net Cups):

Expected Mature Plant Size:

Nozzle Type (influences pump pressure/flow):

Misting Cycle "ON" Time (seconds): Typical: 1-5 seconds

Misting Cycle "OFF" Time (minutes): Typical: 5-15 minutes (veg), 2-5 minutes (clone)

Lighting Type (for power estimation):

No Artificial Lighting

Fluorescent/CFL (Lower power)

LED Grow Lights (Efficient)

HID/HPS (High power)

Aeroponics System Recommendations

System Components & Sizing:

Recommended Reservoir Volume: Liters

Estimated Pump Flow Rate: Liters Per Hour (LPH)

Recommended Number of Misting Nozzles:

For Low-Pressure Misters: Requires a submersible pump.
For Ultra-Fine Foggers: Requires a diaphragm pump with pressure capabilities and fine filtration.

Nutrient Solution Management:

Initial Nutrient Solution Volume: Liters

Estimated Nutrient Solution Replenishment:

General Nutrient Guideline:

Use a balanced, high-quality hydroponic nutrient solution specifically designed for the growth stage (e.g., vegetative, flowering).
Follow the nutrient manufacturer's dilution instructions for aeroponics (often slightly weaker than deep water culture).
Maintain Nutrient Solution Temperature: 18-22°C (65-72°F).
Target pH Range: 5.5 - 6.5 (adjust based on plant type).
Target EC/TDS: Varies greatly by plant type and growth stage. Start low and increase as plants mature.

Operational Considerations (Estimates):

Estimated Daily Pump Run Time: hours

Estimated Daily Lighting Run Time: hours (assuming 16 hours ON for active growth)

Regularly check and clean nozzles to prevent clogging.

This calculator provides basic estimates. For optimal growth, monitor your plants closely and adjust parameters as needed. Experimentation is key in aeroponics!